Zebra CS4070

Scanning 2 - 5
Charging Indications
Battery charge status Press battery
charge button.
If scanner is in
sleep mode, press
scan (+) button to
wake it.
4 green Full charge (12 hours in a
busy environment)
3 green Approximately 3/4 charge
2 green Approximately 1/2 charge
1 green Approximately 1/4 charge
Charge scanner Connect scanner
to a host PC USB
port.
Flashing amber Scanner connects in mass
storage mode, auto-run
application on PC launches
Insert scanner in
charging cradle.
Flashing amber The battery is above the low
battery threshold of 3.4 volts.
The scanner turns on if
removed from the charging
source.
Flashing red The battery is trickle charging
but is well below the low
battery threshold of 3.4 volts.
The scanner does not turn on
if removed from the charging
source.
Charge complete Solid green The scanner turns on if
removed from the charging
source.
Charge error Connect scanner
to a host PC USB
port or insert
scanner in
charging cradle.
Solid amber The battery is above the low
battery threshold but is not
charging due to a faulty
battery or charging source.
Re-seat the scanner in the
charging cradle or connect it
to a host PC USB port. If the
problem persists replace the
charger or the battery.
Solid red The battery is not installed or
is faulty. Re-seat the scanner
in the charging cradle or
connect it to a host PC USB
port. If the problem persists
replace the battery.
Table 2-1 LED Indications (Continued)
Function Performed User Action LED Feedback Other