Wi-Fi Configuration
96
Preferred Configurations for Access Points
The FX Series readers support WPA/WPA2 (http://en.wikipedia.org/wiki/Wi-Fi_Protected_Access) and
WEP128 (http://en.wikipedia.org/wiki/Wired_Equivalent_Privacy) by default over the Administrator
Console.
Other supported protocols are explained in this guide. Refer to the Access Point configuration manual to
configure the Access Point to one of the following modes that match the reader configuration:
• WPA / TKIP
• WPA1 / CCMP
• WEP128
• Open Network
Figure 62 Example Open Network Mode
To Next Page
Loading...
