Scheduling an NQA Test Group 1063
Scheduling an NQA
Test Group
With this configuration, you can set the start time and time period for a test group
to perform the test and start the test.
Configuration prerequisites
Before scheduling an NQA test group, make sure:
■ Required test parameters corresponding to a test type have been configured;
■ For the test which needs the cooperation with the NQA server, configuration
on the NQA server has been completed.
Scheduling an NQA test group
Follow these steps to schedule an NQA test group:
c
CAUTION: After an NQA test group is scheduled, you cannot enter the test group
view or test type view.
Configure the NQA probe
timeout time
probe timeout timeout Optional
By default, the timeout time is 3000
milliseconds.
This parameter is not available for a
UDP-jitter test.
Configure the maximum
number of history records
that can be saved in a test
group
history-records number Optional
50 by default.
Configure the maximum
number of hops a probe
packet traverses in the
network
ttl value Optional
20 by default.
This parameter is not available for a
DHCP test.
Configure the ToS field in
an IP packet header in an
NQA probe packet
tos value Optional
0 by default.
This parameter is not available for a
DHCP test.
Enable the routing table
bypass function
route-option
bypass-route
Optional
Disabled by default.
This parameter is not available for a
DHCP test.
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Schedule an NQA test group nqa schedule admin-name
operation-tag start-time
now lifetime forever
Required
Configure the maximum
number of the tests that the
NQA client can simultaneously
perform
nqa agent max-concurrent
number
Optional
The default number is 2
To Next Page
Loading...
