38 CHAPTER 2: LOGGING IN THROUGH THE CONSOLE PORT
[SW4800G] user-interface aux 0
# Specify not to authenticate the user logging in through the console port.
[SW4800G-ui-aux0] authentication-mode none
# Specify commands of level 2 are available to the user logging in to the AUX user
interface.
[SW4800G-ui-aux0] user privilege level 2
# Set the baud rate of the console port to 19,200 bps.
[SW4800G-ui-aux0] speed 19200
# Set the maximum number of lines the screen can contain to 30.
[SW4800G-ui-aux0] screen-length 30
# Set the maximum number of commands the history command buffer can store
to 20.
[SW4800G-ui-aux0] history-command max-size 20
# Set the timeout time of the AUX user interface to 6 minutes.
[SW4800G-ui-aux0] idle-timeout 6
After the above configuration, to ensure a successful login, the console user needs
to change the corresponding configuration of the terminal emulation program
running on the PC, to make the configuration consistent with that on the switch.
Refer to section “Setting Up the Connection to the Console Port” on page 31 for
more.
Console Port Login
Configuration with
Authentication Mode
Being Password
Configuration Procedure
To do… Use the command… Remarks
Enter system view system-view -
Enter AUX user interface
view
user-interface aux 0 -
Configure to
authenticate users using
the local password
authentication-mode
password
Required
By default, users logging in through
the console port are not
authenticated, while users logging in
through the Modem or Telnet need to
pass the password authentication.
Set the local password set authentication
password { cipher |
simple } password
Required
To Next Page
Loading...
