3Com Switch 4800G 24-Port - Troubleshooting DHCP Relay Agent Configuration

Troubleshooting DHCP Relay Agent Configuration 821
Troubleshooting DHCP
Relay Agent
Configuration
Symptom
DHCP clients cannot obtain any configuration parameters via the DHCP relay
agent.
Analysis
Some problems may occur with the DHCP relay agent or server configuration.
Enable debugging and execute the display command on the DHCP relay agent to
view the debugging information and interface state information for locating the
problem.
Solution
Check that:
■ The DHCP is enabled on the DHCP server and relay agent.
■ The address pool on the same subnet where DHCP clients reside is available on
the DHCP server.
■ The routes between the DHCP server and DHCP relay agent are reachable.
■ The relay agent interface connected to DHCP clients is correlated with correct
DHCP server group and IP addresses for the group members are correct.