EasyManua.ls Logo

3Com Switch 4800G 24-Port - Displaying and Maintaining VLAN; VLAN Configuration Example

3Com Switch 4800G 24-Port
1246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Displaying and Maintaining VLAN 95
Displaying and
Maintaining VLAN
VLAN Configuration
Example
Network requirements
Device A connects to Device B through Trunk port GigabitEthernet 1/0/1;
The default VLAN ID of the port is 100;
This port allows packets from VLAN 2, VLAN 6 through VLAN 50, and VLAN
100 to pass through.
Network diagram
Figure 28 Network diagram for port-based VLAN configuration
Allow an IP-subnet-based
VLAN to pass through the
current Hybrid port
port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
Configure the association
between the Hybrid port and
the IP-subnet-based VLAN
port hybrid ip-subnet-vlan
vlan vlan-id
Required
To do… Use the command… Remarks
To do… Use the command… Remarks
Display the information about
specific VLANs
display vlan [ vlan-id1 [ to
vlan-id2 ] | all | dynamic |
reserved | static ]
Available in any view
Display the information about a
VLAN interface
display interface Vlan-interface
[ vlan-interface-id ]
Available in any view
Display all the ports with MAC
address-based VLAN enabled.
display mac-vlan interface Available in any view
Display the information about
specific MAC address-to-VLAN
entries
display mac-vlan { all | dynamic |
mac-address mac-addr [ mask
mac-mask ] | static | vlan vlan-id }
Available in any view
Display the protocol information
and protocol indexes of specified
VLANs
display protocol-vlan vlan
{ vlan-id [ to vlan-id ] | all }
Available in any view
Display protocol-based VLAN
information on specified interfaces
display protocol-vlan interface
{ interface-type interface-number
[ to interface-type
interface-number ] | all }
Available in any view
Display the IP-subnet-based VLAN
information and IP subnet indexes
of specified VLANs
display ip-subnet-vlan vlan
{ vlan-id [ to vlan-id ] | all }
Available in any view
Display the IP-subnet-based VLAN
information and IP subnet index of
specified ports
display ip-subnet-vlan interface
{ interface-type interface-number
[ to interface-type
interface-number | all }
Available in any view
Clear the statistics on a VLAN
interface
reset counters interface
Vlan-interface [ vlan-interface-id ]
Available in user view
Device A Device B
GE1/0/1
GE1/0/1

Table of Contents

Related product manuals