3Com Switch 4800G 24-Port - Configuring the Root Bridge

Configuring the Root Bridge 213
n
In a network containing switches with both GVRP and MSTP enabled, GVRP
messages travel along the CIST. If you want to advertise a VLAN through GVRP, be
sure to map the VLAN to the CIST (MSTI 0) when configuring the VLAN-to-MSTI
mapping table. For detailed information of GVRP, refer to “GVRP Configuration”
on page 109.
Configuring the Root
Bridge
Configuring an MST
Region
Configuration procedure
Follow these steps to configure an MST region:
“Configuring Leaf Nodes” on page
224
“Configuring an MST Region” on page
213
Required
“Configuring the Work Mode of MSTP
Device” on page 216
Optional
“Configuring the Timeout Factor” on
page 219
Optional
“Configuring the Maximum Transmission
Rate of Ports” on page 220
Optional
“Configuring Ports as Edge Ports” on
page 221
Optional
“Configuring Path Costs of Ports” on
page 225
Optional
“Configuring Port Priority” on page 226 Optional
“Configuring Whether Ports Connect to
Point-to-Point Links” on page 221
Optional
“Configuring the Mode a Port Uses to
Recognize/Send MSTP Packets” on page
227
Optional
“Enabling the Output of Port State
Transition Information” on page 223
Optional
“Enabling the MSTP Feature” on page
224
Required
“Performing mCheck” on page 228 Optional
“Configuring Digest Snooping” on page 229 Optional
“Configuring No Agreement Check” on page 230 Optional
“Configuring Protection Functions” on page 233 Optional
Task Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter MST region view stp region-configuration -
Configure the MST region
name
region-name name Optional
The MST region name is the
MAC address by default.