74 CHAPTER 7: CONFIGURING SOURCE IP ADDRESS FOR TELNET SERVICE PACKETS
n
To perform the configurations listed in Table 20 and Table 21, make sure that
■ The IP address specified is that of the local device.
■ The interface specified exists.
■ If a source IP address (or source interface) is specified, you need to make sure
that the route between the IP addresses (or interface) of both sides is
reachable.
Displaying the source
IP address/Interface
Specified for Telnet
Packets
Follow these steps to display the source IP address/interface specified for Telnet
packets:
Specify the source IP address or
source interface for the switch for
it to log in to another device as a
Telnet client
telnet client source { ip
ip-address | interface
interface-type interface-number }
Optional
Not specified by
default
Table 21 Configure a source IP address for service packets in system view
To do… Use the command… Remarks
To do… Use the command…
Display the source IP address/interface specified for
Telnet packets
display telnet client configuration
To Next Page
Loading...
