738 CHAPTER 51: HABP CONFIGURATION
Configuring an HABP
Client
Configure HABP to work in client mode on a device connected to the
administrative device. Since HABP is enabled and works in client mode by default,
this configuration task is optional.
Follow these steps to configure an HABP client:
Displaying and
Maintaining HABP
Enable HABP habp enable Optional
Enabled by default
Configure HABP to work in
server mode
habp server vlan vlan-id Required
HABP works in client mode by
default.
Set the interval to send HABP
requests
habp timer interval Optional
20 seconds by default
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enable HABP habp enable Optional
Enabled by default
Configure HABP to work in
client mode
undo habp server Optional
HABP works in client mode by
default.
To do… Use the command… Remarks
Display HABP configuration
information
display habp Available in any view
Display HABP MAC address
table entries
display habp table Available in any view
Display HABP packet statistics display habp traffic Available in any view
To Next Page
Loading...
