114 CHAPTER 11: GVRP CONFIGURATION
Displaying and
Maintaining GVRP
GVRP Configuration
Examples
GVRP Configuration
Example I
Network requirements
Configure GVRP for dynamic VLAN information registration and update among
devices, adopting the normal registration mode on ports.
Network diagram
Figure 32 Network diagram for GVRP configuration
Table 26 Dependencies of GARP timers
Timer Lower limit Upper limit
Hold 10 centiseconds Not greater than half of the join timer
setting
Join Not less than two times the hold timer
setting
Less than half of the leave timer setting
Leave Greater than two times the join timer
setting
Less than the LeaveAll timer setting
LeaveAll Greater than the leave timer setting 32765 centiseconds
To do… Use the command… Remarks
Display statistics about GARP display garp statistics
[ interface interface-list ]
Available in any view
Display GARP timers for specified
or all ports
display garp timer [ interface
interface-list ]
Available in any view
Display the local VLAN information
maintained by GVRP
display gvrp local-vlan
interface interface-type
interface-number
Available in any view
Display the current GVRP state display gvrp state interface
interface-type interface-number
vlan vlan-id
Available in any view
Display statistics about GVRP display gvrp statistics
[ interface interface-list ]
Available in any view
Display the global GVRP state display gvrp status Available in any view
Display the information about
dynamic VLAN operations
performed on a port
display gvrp vlan-operation
interface interface-type
interface-number
Available in any view
Clear the GARP statistics reset garp statistics [ interface
interface-list ]
Available in user view
Device A Device B
GE1/0/1
GE1/0/1
To Next Page
Loading...
