Cluster Configuration Task List 911
of the management VLAN can you set the packets without tags from the
management VLAN to pass the ports; otherwise, only the packets with tags
from the management VLAN can pass the ports.
Refer to “Introduction to VLAN” on page 83.
Cluster Configuration
Task List
Before configuring a cluster, you need to determine the roles and functions the
devices play. You also need to configure the related functions, preparing for the
communication between devices within the cluster.
Complete these tasks to configure a cluster:
Tasks Remarks
“Configuring the Management Device” on
page 912
“Enabling NDP Globally and for
Specific Ports” on page 912
Optional
“Configuring NDP Parameters” on
page 912
Optional
“Enabling NTDP Globally and for
Specific Ports” on page 912
Optional
“Configuring NTDP Parameters” on
page 913
Optional
“Manually Collecting NTDP
Information” on page 913
Optional
“Enabling the Cluster Function” on
page 914
Optional
“Establishing a Cluster” on page 914 Required
“Configuring Communication
Between the Management Device
and the Member Devices Within a
Cluster” on page 916
Optional
“Configuring the Destination MAC
Address of Cluster Management
Multicast Packets” on page 916
Optional
“Configuring Cluster Member
Management” on page 916
Optional
“Configuring the Member Devices” on
page 917
“Enabling NDP Globally and for
Specific Ports” on page 917
Optional
“Enabling NTDP Globally and for
Specific Ports” on page 917
Optional
“Manually Collecting NTDP
Information” on page 917
“Enabling the Cluster Function” on
page 917
Optional
“Deleting a Member Device from a
Cluster” on page 917
Optional
“Configuring Access Between the Management Device and Its Member Devices”
on page 918
Optional
“Adding a Candidate Device to a Cluster” on page 919 Optional
“Configuring Advanced Cluster Functions”
on page 919
“Configuring Topology
Management” on page 919
Optional
“Configuring Interaction for a
Cluster” on page 920
Optional
To Next Page
Loading...
