Controlling Route Distribution and Reception 471
Configuring a
Description for a
Peer/Peer Group
Follow these steps to configure description for a peer/peer group:
n
The peer group to be configured with a description must have been created.
Disabling Session
Establishment to a
Peer/Peer Group
Follow these steps to disable session establishment to a peer/peer group:
Logging Peer State
Changes
Follow these steps to configure to log on the session and event information of a
peer/peer group:
n
Refer to “Configuring BGP Basic Functions” on page 381 for information about
the log-peer-change command.
Controlling Route
Distribution and
Reception
The task includes routing information filtering, routing policy application and route
dampening.
Prerequisites Before configuring this task, you have:
■ Enabled the IPv6 function
■ Configured the IPv6 BGP basic functions
To do… Use the command… Remarks
Enter system view system-view -
Enter BGP view bgp as-number Required
Enter IPv6 address family view ipv6-family -
Configure a description for a
peer/peer group
peer { ipv6-group-name |
ipv6-address } description
description-text
Optional
Not configured by default
To do… Use the command… Remarks
Enter system view system-view -
Enter BGP view bgp as-number Required
Enter IPv6 address family view ipv6-family -
Disable session establishment
to a peer/peer group
peer { ipv6-group-name |
ipv6-address } ignore
Optional
Not disabled by default
To do… Use the command… Remarks
Enter system view system-view -
Enter BGP view bgp as-number Required
Enable logging of peer
changes globally
log-peer-change Optional
Enabled by default
Enter IPv6 address family view ipv6-family -
Enable the state change
logging for a peer or peer
group
peer { ipv6-group-name |
ipv6-address } log-change
Optional
Enabled by default
To Next Page
Loading...
