3Com Switch 4800G 24-Port - Configuring Assistant Edge Node

Configuring Assistant Edge Node 1151
Configuration procedure
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] link-delay 0
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] link-delay 0
[Sysname-GigabitEthernet1/0/2] quit
[Sysname] interface gigabitethernet 1/0/4
[Sysname-GigabitEthernet1/0/4] link-delay 0
[Sysname-GigabitEthernet1/0/4] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet 1/0/1 secondary-port gigabitethernet 1/0/2 level 0
[Sysname-rrpp-domain1] ring 2 node-mode edge common-port gigabitethernet 1/0/2 edge-port gigabitethernet 1/0/4
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] ring 2 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable
Configuring Assistant
Edge Node
Configuration Procedure Follow these steps to configure assistant edge node:
c
CAUTION:
■ The control VLAN configured for an RRPP domain must be a new one.
To do… Use the command… Remarks
Enter system view system-view -
Create an RRPP domain and
enter its view
rrpp domain domain-id Required
Specify a control VLAN for the
RRPP domain
control-vlan vlan-id Required
Specify the current device as
the transit node of the
primary ring, and specify the
primary port and the
secondary port
ring ring-id node-mode
transit [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
Required
Specify the current device as
the assistant edge node of the
sub ring, and specify a
common port and an edge
port
ring ring-id node-mode
assistant-edge
[ common-port
interface-type
interface-number ]
[ edge-port interface-type
interface-number ]
Required
Enable the primary ring ring ring-id enable Required
By default, the RRPP ring is
disabled.
Enable the sub ring ring ring-id enable Required
By default, the RRPP ring is
disabled.
Return to system view quit -
Enable RRPP rrpp enable Required
By default, RRPP is disabled.