922 CHAPTER 73: CLUSTER MANAGEMENT CONFIGURATION
Displaying and
Maintaining Cluster
Management
n
■ Support for the display ntdp single-device mac-address command varies
with devices.
■ When you display the cluster topology information, the devices attached to the
switch that is listed in the blacklist will not be displayed.
Cluster Management
Configuration
Examples
Cluster Management
Configuration Example
One
Network requirements
Three switches form a cluster, in which:
■ One device serves as the management device.
■ The other two are the member devices.
The specific requirements are as follows:
■ The management device is connected to the external network through its
Ethernet 1/1 port. The two member devices are connected to Ethernet 1/2 and
Ethernet 1/3 ports of the management device.
To do… Use the command… Remarks
Display NDP configuration
information
display ndp [ interface interface-list ] Available in any
view
Display the global NTDP
information
display ntdp
Display the device
information collected through
NTDP
display ntdp device-list [ verbose ]
Display the detailed NTDP
information of a specified
device
display ntdp single-device mac-address
mac-address
View cluster state and
statistics
display cluster
View the standard topology
information
display cluster base-topology
[ mac-address mac-address | member-id
member-number ]
View the current blacklist of
the cluster
display cluster black-list
View the information of
candidate devices
display cluster candidates
[ mac-address mac-address | verbose ]
Display the current topology
information or the topology
path between two devices
display cluster current-topology
[ mac-address mac-address
[ to-mac-address mac-address ] |
member-id member-number
[ to-member-id member-number ]]
Display members in a cluster display cluster members
[ member-number | verbose ]
Clear NDP statistics reset ndp statistics [ interface
interface-list ]
Available in user
view
To Next Page
Loading...
