Configuring Advanced Cluster Functions 921
c
CAUTION:
■ For the configured log host to take effect, you must execute the info-center
loghost command in system view first. For more information about the
info-center loghost command, refer to “Configuring Information Center” on
page 1009.
■ To isolate management protocol packets of a cluster from packets outside the
cluster, you are recommended to configure to prohibit packets from the
management VLAN from passing the ports that connect the management
device with the devices outside the cluster and configure the NM interface for
the management device.
Configure the TFTP server
shared by the member devices
in the cluster
tftp-server ip-address Required
By default, no TFTP server is
configured for a cluster.
Configure the log host shared
by the member devices in the
cluster
logging-host ip-address Required
By default, no log host is
configured for a cluster.
Configure the SNMP NM host
shared by the member devices
in the cluster
snmp-host ip-address
[ community-string read
string1 write string2 ]
Required
By default, no SNMP host is
configured.
Configure the NM interface of
the management device
nm-interface vlan-interface
vlan-interface-id
Optional
To do… Use the command… Remarks
To Next Page
Loading...
