3Com Switch 4800G 24-Port - Ospfv3 Configuration Examples

OSPFv3 Configuration Examples 453
OSPFv3 Configuration
Examples
Configuring OSPFv3
Areas
Network requirements
In the following figure, all switches run OSPFv3. The AS is split into three areas, in
which, Switch B and Switch C act as ABRs to forward routing information
between areas.
It is required to configure Area 2 as a stub area, reducing LSAs into the area
without affecting route reachability.
Network diagram
Figure 144 Network diagram for OSPFv3 area configuration
Configuration procedure
1 Configure IPv6 addresses for interfaces (omitted)
2 Configure OSPFv3 basic functions
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] ospfv3 1 area 1
[SwitchA-Vlan-interface300] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ospfv3 1 area 1
[SwitchA-Vlan-interface200] quit
# Configure Switch B
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ospfv3
[SwitchB-ospf-1] router-id 2.2.2.2
[SwitchB-ospf-1] quit
[SwitchB] interface vlan-interface 100
OSPFv3
Area 0
OSPFv3
Area 1
OSPFv3
Area 2
Switch A
Vlan-int100
2001::2/64
Vlan-int100
2001::1/64
Vlan-int300
2001:3::1/64
Vlan-int200
2001:1::2/64
Switch C
Vlan-int400
2001:2::1/64
Vlan-int400
2001:2::2/64
Switch B
Vlan-int200
2001:1::1/64
Switch D
Stub