3Com Switch 4800G 24-Port - Configuring BPDU Transparent Transmission

Configuring BPDU Transparent Transmission 143
n
■ BPDU tunneling must be enabled globally before the BPDU tunnel
configuration for a port can take effect.
■ The BPDU tunneling feature is incompatible with the GVRP feature, so these
two features cannot be enabled at the same time. For introduction to GVRP,
refer to “Introduction to GVRP” on page 109.
■ The BPDU tunneling feature is incompatible with the NTDP feature, so these
two features cannot be enabled at the same time. If you want to enable BPDU
tunneling on a port, use the undo ntdp enable command to disable NTDP
first. For introduction to NTDP, refer to “Cluster Management Overview” on
page 905.
Configuring BPDU
Transparent
Transmission
Perform the following tasks to configure BPDU transparent transmission:
Enable BPDU tunneling globally bpdu-tunnel dot1q enable Optional
Enabled by default
Enter
Ethernet
port view or
port group
view
Enter Ethernet
port view
interface interface-type
interface-number
Required
Use either command.
Configurations made in
Ethernet port view will take
effect on the current port
only; configurations made in
port group view will take
effect on all ports in the port
group.
Enter port group
view
port-group { manual
port-group-name |
aggregation agg-id }
Enable BPDU tunneling for the
port(s)
bpdu-tunnel dot1q enable Required
Disabled by default
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enable BPDU tunneling globally bpdu-tunnel dot1q enable Optional
Enabled by default
Enter
Ethernet
port view or
port group
view
Enter Ethernet
port view
interface interface-type
interface-number
Required
Use either command.
Configurations made in
Ethernet port view will take
effect on the current port
only; configurations made in
port group view will take
effect on all ports in the port
group.
Enter port group
view
port-group { manual
port-group-name |
aggregation agg-id }
Enable BPDU tunneling on the
port(s)
bpdu-tunnel dot1q enable Required
Disabled by default
Disable STP on the port(s) stp disable Required
Enabled by default
Enable BPDU tunneling for STP
on the port(s)
bpdu-tunnel dot1q stp Required
Disabled by default