3Com Switch 4800G 24-Port - Controlling Network Management Users by Source IP Addresses

78 CHAPTER 8: CONTROLLING LOGIN USERS
Controlling Network
Management Users by
Source IP Addresses
You can manage a Switch 4800G through network management software.
Network management users can access switches through SNMP.
You need to perform the following two operations to control network
management users by source IP addresses.
■ Defining an ACL
■ Applying the ACL to control users accessing the switch through SNMP
Prerequisites The controlling policy against network management users is determined, including
the source IP addresses to be controlled and the controlling actions (permitting or
denying).
Controlling Network
Management Users by
Source IP Addresses
Controlling network management users by source IP addresses is achieved by
applying basic ACLs, which are numbered from 2000 to 2999. Refer to
“Configuring an Advanced IPv4 ACL” on page 844 for information about defining
an ACL.
n
You can specify different ACLs while configuring the SNMP community name, the
SNMP group name and the SNMP user name.
To do… Use the command… Remarks
Enter system view system-view -
Create a basic ACL or
enter basic ACL view
acl number acl-number [ match-order
{ config | auto }]
As for the acl
number
command, the
config keyword is
specified by
default.
Define rules for the ACL rule [ rule-id ] { permit | deny } [ source
{ sour-addr sour-wildcard | any } |
time-range time-name | fragment |
logging ]*
Required
Quit to system view quit -
Apply the ACL while
configuring the SNMP
community name
snmp-agent community { read | write }
community-name [ mib-view view-name |
acl acl-number ]*
Required
Apply the ACL while
configuring the SNMP
group name
snmp-agent group { v1 | v2c }
group-name [ read-view read-view ]
[ write-view write-view ] [ notify-view
notify-view ] [ acl acl-number ]
snmp-agent group v3
group-name
[ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl
acl-number ]
Required
Apply the ACL while
configuring the SNMP user
name
snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl acl-number ]
snmp-agent usm-user v3 user-name
group-name [ authentication-mode { md5
| sha } auth-password [ privacy-mode
{ des56 | aes128 } priv-password ]] [acl
acl-number ]
Required