Displaying and Maintaining AAA/RADIUS/HWTACACS 775
n
■ For real-time accounting, a NAS must transmit the accounting information of
online users to the HWTACACS accounting server periodically. Note that if the
device does not receive any response to the information, it does not disconnect
the online users forcibly
■ The real-time accounting interval must be a multiple of 3.
■ The setting of the real-time accounting interval somewhat depends on the
performance of the NAS and the HWTACACS server: a shorter interval requires
higher performance.
Displaying and
Maintaining
AAA/RADIUS/HWTAC
ACS
Displaying and
Maintaining AAA
Displaying and
Maintaining RADIUS
Set the real-time accounting
interval
timer realtime-accounting
minutes
Optional
12 minutes by default
To do… Use the command… Remarks
To do… Use the command… Remarks
Display the configuration
information of a specified ISP
domain or all ISP domains
display domain [ isp-name ] Available in any
view
Display information about
specified or all user
connections
display connection [ access-type
{ dot1x | mac-authentication | portal }
| domain isp-name | interface
interface-type interface-number | ip
ip-address | mac mac-address |
ucibindex ucib-index | user-name
user-name | vlan vlan-id ]
Available in any
view
Display information about
specified or all local users
display local-user [ idle-cut { disable |
enable } | service-type { ftp |
lan-access | ssh | telnet | terminal } |
state { active | block } | user-name
user-name | vlan vlan-id ]
Available in any
view
To do… Use the command… Remarks
Display the configuration
information of a specified
RADIUS scheme or all RADIUS
schemes
display radius scheme
[ radius-scheme-name ]
Available in any
view
Display statistics about
RADIUS packets
display radius statistics Available in any
view
Display information about
buffered stop-accounting
requests that get no
responses
display stop-accounting-buffer
{ radius-scheme radius-server-name |
session-id session-id | time-range
start-time stop-time | user-name
user-name }
Available in any
view
Clear RADIUS statistics reset radius statistics Available in user
view
To Next Page
Loading...
