Enabling the NQA Client 1051
Enabling the NQA
Client
Configurations on the NQA client take effect only when the NQA client is enabled.
Follow these steps to enable the NQA client:
Creating an NQA Test
Group
One test corresponds to one test group. You can configure test types after you
create a test group and enter the test group view.
Follow theses steps to create an NQA test group:
n
If you execute the nqa entry command to enter the test group view with test type
configured, you will enter the test type view of the test group directly.
Configuring an NQA
Test Group
Configuring the
ICMP-echo Test
The ICMP test is used to test reachability of the destination host according to the
ICMP-echo reply or timeout information.
Follow these steps to configure the ICMP-echo test:
To do… Use the command… Remarks
Enter system view system-view -
Enable the NQA server nqa server enable Required
Disabled by default.
Configure the UDP or TCP
listening function on the NQA
server
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Required
The IP address and port
number must be consistent
with those configured on the
NQA client and must be
different from those of an
existing listening service.
To do… Use the command… Remarks
Enter system view system-view -
Enable the NQA client nqa agent enable Optional
Enabled by default.
To do… Use the command… Remarks
Enter system view system-view -
Create an NQA test group
and enter the NQA test group
view
nqa entry admin-name
operation-tag
Required
To do… Use the command… Remarks
Enter system view system-view -
To Next Page
Loading...
