1052 CHAPTER 86: NQA CONFIGURATION
Enter NQA test group view nqa entry admin-name
operation-tag
-
Configure the test type as
ICMP-echo and enter test type
view
type icmp-echo Required
Configure the destination
address for a test operation
destination ip ip-address Required
By default, no destination IP
address is configured for a
test operation.
Configure the size of probe
packets sent
data-size size Optional
100 bytes by default.
Configure the string used to
fill a probe packet
data-fill string Optional
The string of fill characters of
a probe packet is the string
corresponding with the ASCII
code 00 to 09 by default.
Specify the IP address of an
interface as the source IP
address of an ICMP-echo
request
source interface
interface-type
interface-number
Optional
By default, no interface
address is specified as the
source IP address of ICMP
probe requests.
If you use the source ip
command to configure the
source IP address of
ICMP-echo probe requests,
the source interface
command is invalid.
The interface specified by this
command must be up.
Otherwise, the probe will fail.
Configure the source IP
address of a probe request
source ip ip-address Optional
By default, no source IP
address is specified.
If no source IP address is
specified, but the source
interface is specified, the IP
address of the source
interface is taken as the
source IP address of ICMP
probe requests.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the probe
will fail.
Configure the next hop IP
address for an ICMP-echo
request
next-hop ip-address Optional
By default, no next hop IP
address is configured.
Configure common optional
parameters
Refer to “Configuring
Optional Parameters Common
to an NQA Test Group” on
page 1062
Optional
To do… Use the command… Remarks
To Next Page
Loading...
