EasyManua.ls Logo

3Com Switch 4800G 24-Port - Page 1053

3Com Switch 4800G 24-Port
1246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring an NQA Test Group 1053
Configuring the DHCP
Test
The DHCP test is mainly used to test the existence of a DHCP server on the
network as well as the time necessary for the DHCP server to respond to a client
request and assign an IP address to the client.
Configuration prerequisites
Before performing a DHCP test, you need to configure the DHCP server. If the
NQA (DHCP client) and the DHCP server are not in the same network segment,
you need to configure a DHCP relay. For more information, refer to “DHCP Server
Configuration” on page 797 and “DHCP Relay Agent Configuration” on page
813.
Configuring the DHCP test
Follow these steps to configure the DHCP test:
n
As DHCP test is a process to simulate address allocation in DHCP, the IP address of
the interface performing the DHCP test will not be changed.
Configuring the FTP Test The FTP test is mainly used to test the connection with a specified FTP server and
the time necessary for the FTP client to transfer a file to or download a file from
the FTP server.
Configuration prerequisites
Before the FTP test, you need to perform some configurations on the FTP server.
For example, you need to configure the username and password used to log onto
the FTP server. For the FTP server configuration, refer to “Configuring the FTP
Server” on page 996.
Configuring the FTP test
Follow these steps to configure the FTP test:
To do… Use the command… Remarks
Enter system view system-view -
Enter NQA test group view nqa entry admin-name
operation-tag
-
Configure the test type as
DHCP and enter test type
view
type dhcp Required
Specify an interface for a
DHCP test
operation interface
interface-type interface-number
Required
By default, no interface is
specified to perform a DHCP
test.
The interface specified by the
source interface command
must be up; otherwise, the
test fails.
Configure common
optional parameters
Refer to “Configuring Optional
Parameters Common to an NQA
Test Group” on page 1062
Optional
To do… Use the command… Remarks
Enter system view system-view -

Table of Contents

Related product manuals