1054 CHAPTER 86: NQA CONFIGURATION
Configuring the HTTP
Tes t
The HTTP test is used to test the connection with a specified HTTP server and the
time required to obtain data from the HTTP server.
Configuration prerequisites
Before performing an HTTP test, you need to configure the HTTP server.
Configuring the HTTP test
Follow these steps to configure the HTTP test:
Enter NQA test group view nqa entry admin-name
operation-tag
-
Configure the test type as FTP
and enter test type view
type ftp Required
Configure the destination
address for a test operation
destination ip ip-address Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a
test operation is the IP address
of the FTP server.
Configure the source IP
address of a probe request
source ip ip-address Required
By default, no source IP address
is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Configure the operation type operation { get | put } Optional
By default, the operation type
for the FTP is get, that is,
obtaining files from the FTP
server.
Configure a login username username name Required
By default, no login username is
configured.
Configure a login password password password Required
By default, no login password is
configured.
Specify a file to be transferred
between the FTP server and
the FTP client
filename file-name Required
By default, no file is specified.
Configure common optional
parameters
Refer to “Configuring
Optional Parameters
Common to an NQA Test
Group” on page 1062
Optional
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter NQA test group view nqa entry admin-name
operation-tag
-
To Next Page
Loading...
