3Com Switch 4800G 24-Port - PIM Configuration Examples

PIM Configuration Examples 659
PIM Configuration
Examples
PIM-DM Configuration
Example
Network requirements
■ Receivers receive VOD information through multicast. The receiver groups of
different organizations form stub networks, and one or more receiver hosts
exist in each stub network. The entire PIM domain operates in the dense mode.
■ Host A and Host C are multicast receivers in two stub networks.
■ Switch D connects to the network that comprises the multicast source (Source)
through VLAN-interface 300.
■ Switch A connects to stub network N1 through VLAN-interface 100, and to
Switch D through VLAN-interface 103.
■ Switch B and Switch C connect to stub network N2 through their respective
VLAN-interface 200, and to Switch D through VLAN-interface 101 and
VLAN-interface 102 respectively.
■ IGMPv2 is to run between Switch A and N1, and between Switch B/Switch C
and N2.
Network diagram
Figure 196 Network diagram for PIM-DM configuration
Device Interface IP address Device Interface IP address
Switch A Vlan-int100 10.110.1.1/24 Switch D Vlan-int300 10.110.5.1/24
Vlan-int103 192.168.1.1/24 Vlan-int103 192.168.1.2/24
Switch B Vlan-int200 10.110.2.1/24 Vlan-int101 192.168.2.2/24
Vlan-int101 192.168.2.1/24 Vlan-int102 192.168.3.2/24
Ethernet
EthernetEthernet
Source
10.110.5.100/24
PIM-DM
Switch A
Switch B
Switch C
Switch D
Receiver
Host A
Host B
Host C
Host D
Receive
r
N1N2
Vlan-int100
Vlan-int200
Vlan-int200
Vlan-int300 Vlan-int101
Vlan-int101
V
l
a
n
-
i
n
t
1
02
V
la
n
-i
n
t
10
2
V
l
a
n
-
i
n
t
1
0
3
Vl
a
n-i
n
t1
0
3