3Com Switch 4800G 24-Port - Configuring Port Priority Trust Mode

886 CHAPTER 69: PRIORITY MAPPING
Configuration
Prerequisites
The port priority of the port is determined.
Configuration Procedure Follow these steps to configure port priority:
Configuration Examples Network requirements
Configure the port priority to 7.
Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure port priority of GigabitEthernet1/0/1.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos priority 7
Configuring Port
Priority Trust Mode
You can configure the switch to trust the DSCP precedence of the received
packets. In this case, the switch searches the dscp-dot1p/dp/dscp mapping table
for the corresponding precedence according to the DSCP precedence of the
packets and marks the received packets with the precedence.
Configuration
Prerequisites
It is determined to trust the DSCP precedence of received packets.
Configuration Procedure Follow these steps to configure the port priority trust mode:
To do… Use the command… Remarks
Enter system view system-view -
Enter port
view or port
group view
Enter port
view
interface interface-type
interface-number
Perform either of the two
operations.
The configuration performed in
Ethernet port view applies to the
current port only. The
configuration performed in port
group view applies to all the
ports in the port group.
Enter port
group
view
port-group { manual
port-group-name |
aggregation agg-id }
Configure port priority qos priority priority-value Required
By default, the port priority is 0.
To do… Use the command… Remarks
Enter system view system-view -
Enter port
view or
port group
view
Enter port
view
interface interface-type
interface-number
Perform either of the two
operations.
The configuration performed in
Ethernet port view applies to the
current port only. The
configuration performed in port
group view applies to all the
ports in the port group.
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }