3Com Switch 4800G 24-Port - Displaying and Maintaining Priority Mapping

Displaying and Maintaining Priority Mapping 887
Configuration Examples Network requirements
Configure to trust the DSCP precedence of the received packets.
Configuration procedure
# Enter system view.
<Sysname> system-view
# Enter port view.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
# Configure to trust the DSCP precedence of the received packets.
[Sysname-GigabitEthernet1/0/1] qos trust dscp
Displaying and
Maintaining Priority
Mapping
Configure to trust the
DSCP precedence of the
received packets
qos trust dscp Required
By default, the 802.1p
precedence of the received
packets is trusted.
To do… Use the command… Remarks
To do… Use the command… Remarks
Display the information about
a specified priority mapping
table
display qos map-table [ dot1p-dp |
dot1p-lp | dscp-dot1p | dscp-dp |
dscp-dscp ]
Available in any
view
Display the priority trust
mode configured for a port
display qos trust interface
[ interface-type interface-number ]