880 CHAPTER 68: CONGESTION MANAGEMENT
Configuration Examples Network requirements
Configure GigabitEthernet1/0/1 to adopt SP queue scheduling algorithm.
Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure an SP queue for GigabitEthernet1/0/1 port.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos sp
Configuring a WRR
Queue
By default, SP queue scheduling algorithm is adopted on all the ports. You can
adopt WRR queue scheduling algorithm as required.
Configuration Procedure Follow these steps to configure WRR queues:
Enter
port view
or port
group
view
Enter
port
view
interface interface-type
interface-number
Perform either of the two operations.
The configuration performed in
Ethernet port view applies to the
current port only. The configuration
performed in port group view applies
to all the ports in the port group.
Enter
port
group
view
port-group { manual
port-group-name |
aggregation agg-id }
Configure SP queue
scheduling
algorithm
qos sp Required
By default, all the ports adopt the
WRR queue scheduling algorithm,
with the weight values assigned to
queue 0 through queue 7 being 1, 2,
3, 4, 5, 9, 13, and 15.
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter port
view or
port group
view
Enter port
view
interface interface-type
interface-number
Perform either of the two
operations.
The configuration performed in
Ethernet port view applies to the
current port only. The
configuration performed in port
group view applies to all the ports
in the port group
Enter port
group
view
port-group { manual
port-group-name | aggregation
agg-id }
Configure WRR queue
scheduling
qos wrr queue-id group
group-id weight schedule-value
Required
By default, all the ports adopt the
WRR queue scheduling
algorithm, with the weight values
assigned to queue 0 through
queue 7 being 1, 2, 3, 4, 5, 9, 13,
and 15.
To Next Page
Loading...
