Console Port Login Configuration with Authentication Mode Being Password 39
Note that if you configure to authenticate the users in the password mode, the
command level available to users logging in to a switch depends on both the
Configure
the console
port
Set the
baud rate
speed speed-value Optional
The default baud rate of an AUX port
(also the console port) is 9,600 bps.
Set the
check
mode
parity { even | mark |
none | odd | space }
Optional
By default, the check mode of a
console port is set to none, that is, no
check bit.
Set the
stop bits
stopbits { 1 | 1.5 | 2 } Optional
The default stop bits of a console port
is 1.
Set the
data bits
databits { 5 | 6 | 7 | 8 } Optional
The default data bits of a console port
is 8.
Configure the command
level available to users
logging in to the user
interface
user privilege level level Optional
By default, commands of level 3 are
available to users logging in to the
AUX user interface.
Define a shortcut key for
starting terminal sessions
activation-key character Optional
By default, pressing Enter key starts
the terminal session.
Define a shortcut key for
aborting tasks
escape-key { default |
character }
Optional
The default shortcut key combination
for aborting tasks is < Ctrl+C >.
Make terminal services
available to the user
interface
shell Optional
By default, terminal services are
available in all user interfaces.
Set the maximum
number of lines the
screen can contain
screen-length
screen-length
Optional
By default, the screen can contain up
to 24 lines.
You can use the screen-length 0
command to disable the function to
display information in pages.
Set history command
buffer size
history-command
max-size value
Optional
The default history command buffer
size is 10. That is, a history command
buffer can store up to 10 commands
by default.
Set the timeout time for
the user interface
idle-timeout minutes
[ seconds ]
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no operation
is performed in the user interface
within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
To do… Use the command… Remarks
To Next Page
Loading...
