NQA Configuration Examples 1067
Network diagram
Figure 312 Network diagram for the HTTP test
Configuration procedure
# Create an HTTP test group and configure related test parameters.
<DeviceA> system-view
[DeviceA] nqa entry admin test
[DeviceA-nqa-admin-test] type http
[DeviceA-nqa-admin-test-http] destination ip 10.2.2.2
[DeviceA-nqa-admin-test-http] operation get
[DeviceA-nqa-admin-test-http] url /index.htm
[DeviceA-nqa-admin-test-http] http-version v1.0
[DeviceA-nqa-admin-test-http] quit
# Enable the HTTP test.
[DeviceA] nqa schedule admin test start-time now lifetime forever
# Display results of an HTTP test.
[DeviceA] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-03-27 13:40:36.2
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
UDP-jitter Test
Configuration Example
Network requirements
Use the NQA UDP-jitter function to test the delay jitter of packet transmission
between Device A and Device B.
IP network
NQA Client
10 .1 .1. 1/8 10. 2.2.2 /8
HTTP Server
Switch A
To Next Page
Loading...
