IPv6-Based VRRP Configuration Examples 1101
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-
local
# Set the authentication mode for standby group 1 to simple and authentication
key to hello.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 authentication-mode simpl
e hello
# Set the VRRP advertisement interval to 500 centiseconds.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 timer advertise 500
# Set Switch B to work in preemption mode. The preemption delay is five seconds.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay
5
3 Verify the configuration
After the configuration, Host B can be pinged through on Host A. You can use the
display vrrp ipv6 command to verify the configuration.
# Display detailed information of standby group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 500
Admin Status : UP State : Master
Config Pri : 110 Run Pri : 110
Preempt Mode : YES Delay Time : 5
Auth Type : SIMPLE TEXT Key : hello
Track IF : Vlan-interface3 Pri Reduced : 30
Virtual IP : FE80::10
Virtual MAC : 0000-5e00-0201
Master IP : FE80::1
# Display detailed information of standby group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 500
Admin Status : UP State : Backup
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 5
Auth Type : SIMPLE TEXT Key : hello
Virtual IP : FE80::10
Master IP : FE80::1
The above information indicates that in standby group 1 Switch A is the master,
Switch B is the backup and packets sent from Host A to Host B are forwarded by
Switch A.
To Next Page
Loading...
