GVRP Configuration Examples 117
[DeviceB-GigabitEthernet1/0/1] gvrp
[DeviceB-GigabitEthernet1/0/1] quit
# Create VLAN 3 (a static VLAN).
[Sysname] vlan 3
3 Verify the configuration
# Display dynamic VLAN information on Device A.
[DeviceA] display vlan dynamic
No dynamic vlans exist!
# Display dynamic VLAN information on Device B.
[DeviceB] display vlan dynamic
Now, the following dynamic VLAN exist(s):
2
GVRP Configuration
Example III
Network requirements
To prevent dynamic VLAN information registration and update among devices, set
the GVRP registration mode to forbidden on Device A and normal on Device B.
Network diagram
Figure 34 Network diagram for GVRP configuration
Configuration procedure
1 Configure Device A
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port GigabitEthernet 1/0/1 as a Trunk port, allowing all VLANs to pass.
[DeviceA] interface GigabitEthernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-type trunk
[DeviceA-GigabitEthernet1/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 1/0/1.
[DeviceA-GigabitEthernet1/0/1] gvrp
# Set the GVRP registration type to forbidden on the port.
[DeviceA-GigabitEthernet1/0/1] gvrp registration forbidden
[DeviceA-GigabitEthernet1/0/1] quit
# Create VLAN 2 (a static VLAN).
Device A Device B
GE1/0/1
GE1/0/1
To Next Page
Loading...
