1174 CHAPTER 91: PORT SECURITY CONFIGURATION
Retransmission times for timeout = 5
Interval for realtime accounting(minute) = 15
Retransmission times of realtime-accounting packet = 5
Retransmission times of stop-accounting packet = 500
Quiet-interval(min) = 5
Username format = without-domain
Data flow unit = Byte
Packet unit = one
Use the following command to view the configuration information of the ISP
domain named sun:
<Switch> display domain sun
Domain = sun
State = Active
Access-limit = 30
Accounting method = Required
Default authentication scheme : radius=radsun
Default authorization scheme : local
Default accounting scheme : local
Domain User Template:
Idle-cut = Disable
Self-service = Disable
Use the following command to view the port security configuration information:
<Switch> display port-security interface gigabitethernet 1/0/1
Equipment port-security is enabled
Trap is disabled
Disableport Timeout: 20s
OUI value:
Index is 1, OUI value is 123401
Index is 2, OUI value is 123402
Index is 3, OUI value is 123403
Index is 4, OUI value is 123404
Index is 5, OUI value is 123405
GigabitEthernet1/0/1 is link-up
Port mode is userLoginWithOUI
NeedToKnow mode is disabled
Intrusion Protection mode is NoAction
Max MAC address number is not configured
Stored MAC address number is 0
Authorization is permitted
After an 802.1x user gets online, you can see that the number of secure MAC
addresses stored is 1. You can also use the following command to view
information about 802.1x users:
<Switch> display dot1x interface gigabitethernet 1/0/1
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
Configuration: Transmit Period 30 s, Handshake Period 15 s
Quiet Period 60 s, Quiet Period Timer is disabled
Supp Timeout 30 s, Server Timeout 100 s
The maximal retransmitting times 2
The maximum 802.1X user resource number is 1024 per slot
Total current used 802.1X resource number is 1
To Next Page
Loading...
