3Com Switch 4800G 24-Port - Page 171

Link Aggregation Configuration Example 171
<SwitchA> system-view
[SwitchA] link-aggregation group 1 mode static
# Add ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to the group.
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] port link-aggregation group 1
[SwitchA-GigabitEthernet1/0/1] interface GigabitEthernet 1/0/2
[SwitchA-GigabitEthernet1/0/2] port link-aggregation group 1
[SwitchA-GigabitEthernet1/0/2] interface GigabitEthernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] port link-aggregation group 1
3 Configure a service loop group
# Create a manual aggregation group.
<SwitchA> system-view
[SwitchA] link-aggregation group 1 mode manual
# Specify this group to be a tunnel service loop group.
[SwitchA] link-aggregation group 1 service-type tunnel
# Assign port GigabitEthernet 1/0/1 to the service loop group.
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] undo stp
[SwitchA-GigabitEthernet1/0/1] port link-aggregation group 1