Configuring RIP Route Control 265
Follow these steps to disable RIP from receiving host routes:
n
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
Advertising a Default
Route
You can configure RIP to advertise a default route with A specified metric to RIP
neighbors.
Follow these steps to configure RIP to advertise a default route:
n
The router enabled to advertise a default route does not receive default routes
from RIP neighbors.
Configuring
Inbound/Outbound
Route Filtering
The device supports route filtering. You can filter routes by configuring the
inbound and outbound route filtering policies via referencing an ACL or IP prefix
list. You can also configure the router to receive only routes from a specified
neighbor.
Follow these steps to configure route filtering:
To do… Use the command… Remarks
Enter system view system-view -
Enter RIP view rip [ process-id ] -
Disable RIP from receiving
host routes
undo host-route Required
Enabled by default
To do… Use the command… Remarks
Enter system view system-view --
Enter RIP view rip [ process-id ] --
Enable RIP to advertise a
default route
default-route originate
cost value
Required
Not enabled by default
To do… Use the command… Remarks
Enter system view system-view --
Enter RIP view rip [ process-id ] --
Configure the filtering of
incoming routes
filter-policy { acl-number |
gateway ip-prefix-name |
ip-prefix ip-prefix-name
[ gateway ip-prefix-name ]}
import [ interface-type
interface-number ]
Required
Not configured by default
Configure the filtering of
outgoing routes
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [ protocol
[ process-id ] | interface-type
interface-number ]
Required
Not configured by default
To Next Page
Loading...
