EasyManua.ls Logo

3Com Switch 4800G 24-Port - Page 449

3Com Switch 4800G 24-Port
1246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring OSPFv3 Routing Information Management 449
Configuring the
Maximum Number of
OSPFv3 Load-balanced
Routes
If multiple routes to a destination are available, using load balancing to send IPv6
packets on these routes in turn can improve link utility.
Follow these steps to configure the maximum number of load-balanced routes:
Configuring a Priority
for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each
protocol. When these routing protocols find the same route, the route found by
the protocol with the highest priority is selected.
Follow these steps to configure a priority for OSPFv3:
Configuring OSPFv3
Route Redistribution
Follow these steps to configure OSPFv3 route redistribution:
n
Using the import-route command on a router makes the router become an
ASBR.
To do… Use the command… Remarks
Enter system view system-view -
Enter OSPFv3 view ospfv3 [ process-id ] -
Specify the maximum number
of load-balanced routes
maximum load-balancing
maximum
Optional
4 by default
To do… Use the command… Remarks
Enter system view system-view -
Enter OSPFv3 view ospfv3 [ process-id ] -
Configure a priority for
OSPFv3
preference [ ase ]
[ route-policy
route-policy-name ]
preference
Optional
By default, the priority of OSPFv3
interval routes is 10, and priority
of OSPFv3 external routes is 150.
To do… Use the command… Remarks
Enter system view system-view -
Enter OSPFv3 view ospfv3 [ process-id ] -
Specify a default cost for
redistributed routes
default cost value Optional
Defaults to 1
Redistribute routes from
another protocol
import-route { isisv6
process-id | ospfv3 process-id
| ripng process-id | bgp4+
[ allow-ibgp ] | direct |
static } [ cost value | type
type | route-policy
route-policy-name ] *
Required
Not configured by default
Configure the filtering of
outgoing redistributed routes
filter-policy { acl6-number |
ipv6-prefix
ipv6-prefix-name } export
[ isisv6 process-id | ospfv3
process-id | ripng process-id |
bgp4+ | direct | static ]
Optional
Not configured by default

Table of Contents

Related product manuals