Console Port Login Configuration with Authentication Mode Being Scheme 45
■ Set the service type of the local user to Terminal.
■ Configure to authenticate the user logging in through the console port in the
scheme mode.
■ The commands of level 2 are available to the user logging in to the AUX user
interface.
■ The baud rate of the console port is 19,200 bps.
■ The screen can contain up to 30 lines.
■ The history command buffer can store up to 20 commands.
■ The timeout time of the AUX user interface is 6 minutes.
Network diagram
Figure 9 Network diagram for AUX user interface configuration (with the authentication
mode being scheme)
Configuration procedure
# Enter system view.
<SW4800G> system-view
# Create a local user named guest and enter local user view.
[SW4800G] local-user guest
# Set the authentication password to 123456 (in plain text).
[SW4800G-luser-guest] password simple 123456
# Set the service type to Terminal, Specify commands of level 2 are available to the
user logging in to the AUX user interface.
[SW4800G-luser-guest] service-type terminal level 2
[SW4800G-luser-guest] quit
# Enter AUX user interface view.
[SW4800G] user-interface aux 0
# Configure to authenticate the user logging in through the console port in the
scheme mode.
User PC running Telnet
Ethernet
GE1/0/1
To Next Page
Loading...
