3Com Switch 4800G 24-Port - Page 479

Configuring a Large Scale IPv6 BGP Network 479
Create a pure EBGP peer group
Follow these steps to configure a pure EBGP group:
n
■ To create a pure EBGP peer group, you need to specify an AS number for the
peer group.
■ If a peer was added into an EBGP peer group, you cannot specify any AS
number for the peer group.
Create a mixed EBGP peer group
Follow these steps to create a mixed EBGP peer group:
Enter BGP view bgp as-number Required
Not enabled by default
Enter IPv6 address family view ipv6-family -
Create an IBGP peer group group ipv6-group-name
[ internal ]
Required
Add a peer into the group peer ipv6-address group
ipv6-group-name
[ as-number as-number ]
Required
Not added by default
To do… Use the command… Remarks
Enter system view system-view -
Enter BGP view bgp as-number Required
Not enabled by default
Enter IPv6 address family view ipv6-family -
Create an EBGP peer group group ipv6-group-name
external
Required
Configure the AS number for
the peer group
peer ipv6-group-name
as-number as-number
Required
Not configured by default
Add an IPv6 peer into the peer
group
peer ipv6-address group
ipv6-group-name
Required
Not added by default
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter BGP view bgp as-number Required
Not enabled by default
Enter IPv6 address family view ipv6-family -
Create an EBGP peer group group ipv6-group-name
external
Required
Specify the AS number of an
IPv6 peer
peer ipv6-address
as-number as-number
Required
Not specified by default
Add the IPv6 peer into the
peer group
peer ipv6-address group
ipv6-group-name
Required
Not added by default