Configuring a Large Scale IPv6 BGP Network 481
n
■ In general, since the route reflector forwards routing information between
clients, it is not required to make clients of a route reflector fully meshed. If
clients are fully meshed, it is recommended to disable route reflection between
clients to reduce routing costs.
■ If a cluster has multiple route reflectors, you need to specify the same cluster ID
for these route reflectors to avoid routing loops.
Configure the cluster ID of
the route reflector
reflector cluster-id cluster-id Optional
By default, a route reflector
uses its router ID as the cluster
ID
To do… Use the command… Remarks
To Next Page
Loading...
