3Com Switch 4800G 24-Port - Page 522

522 CHAPTER 39: DUAL STACK CONFIGURATION
Enable the IPv6 packet forwarding function ipv6 Required
Disabled by
default.
Enter interface view interface interface-type
interface-number
-
Configure an IPv4 address for the interface ip address ip-address
{ mask | mask-length }
[ sub ]
Required
By default, no IP
address is
configured.
Configure
an IPv6
address on
the interface
Configure
IPv6 global
unicast
address or
local address
Manually specify
an IPv6 address
ipv6 address
{ ipv6-address
prefix-length |
ipv6-address/prefix-length
}
Use either
command.
By default, no
local address or
global unicast
address is
configured on an
interface
Configure an IPv6
address in the
EUI-64 format
ipv6 address
ipv6-address/prefix-length
eui-64
Configure
IPv6
link-local
address
Automatically
create an IPv6
link-local address
ipv6 address auto
link-local
Optional
By default, after
you configured
an IPv6 local
address or global
unicast address, a
link local address
is automatically
created.
Manually specify
an IPv6 link-local
address
ipv6 address
ipv6-address link-local
To do… Use the command… Remarks