3Com Switch 4800G 24-Port - Page 611

IPv6 Multicast VLAN Configuration Examples 611
Network diagram
Figure 183 Network diagram for IPv6 multicast VLAN configuration
Configuration procedure
1 Enable IPv6 forwarding and configure IPv6 addresses of the interfaces of each
device.
Enable IPv6 forwarding and configure the IPv6 address and address prefix for each
interface as per Figure 183. The detailed configuration steps are omitted here.
2 Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable
MLD on GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim ipv6 dm
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface GigabitEthernet1/0/2
[RouterA-GigabitEthernet1/0/2] pim ipv6 dm
[RouterA-GigabitEthernet1/0/2] quit
3 Configure Switch A
# Enable MLD Snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 11 and add GigabitEthernet 1/0/2 into VLAN 11.
Source
Router A
Switch A
Host A
Receiver
Host B
Receiver
Host C
Receiver
GE1/0/2
GE1/0/3
Vlan-int1024
2001::2/64
GE1/0/1
VLAN 13VLAN 11
GE1/0/4
1::1/64
GE1/0/2
1::2/64
GE1/0/1
2001::1/64
VLAN 12
VLAN 1024
MLD querier