PIM Configuration Examples 667
■ IGMPv3 is to run between Switch A and N1, and between Switch B/Switch C
and N2.
Network diagram
Figure 198 Network diagram for PIM-SSM configuration
Configuration procedure
1 Configure the interface IP addresses and unicast routing protocol for each switch
Configure the IP address and subnet mask for each interface as per Figure 198.
Detailed configuration steps are omitted here.
Configure the OSPF protocol for interoperation among the switches in the PIM-SM
domain. Ensure the network-layer interoperation among Switch A, Switch B,
Switch C, Switch D and Switch E in the PIM-SM domain and enable dynamic
update of routing information among the switches through a unicast routing
protocol. Detailed configuration steps are omitted here.
2 Enable IP multicast routing, and enable PIM-SM on each interface
Device Interface IP address Device Interface IP address
Switch A Vlan-int100 10.110.1.1/24 Switch D Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.1/24 Vlan-int101 192.168.1.2/24
Vlan-int102 192.168.9.1/24 Vlan-int105 192.168.4.2/24
Switch B Vlan-int200 10.110.2.1/24 Switch E Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.1/24 Vlan-int103 192.168.2.2/24
Switch C Vlan-int200 10.110.2.2/24 Vlan-int102 192.168.9.2/24
Vlan-int104 192.168.3.1/24 Vlan-int105 192.168.4.1/24
Ethernet
EthernetEthernet
Source
10.110.5.100/24
PIM-SM
Switch A
Switch B
Switch C
Switch D
Receiver
Host A
Host B
Host C
Host D
Receiver
N1N2
Switch E
Vlan-int100
Vlan-int200
Vlan-int200
Vlan-int300
Vlan-int102
Vlan-int102
Vl
a
n
-
in t10 1
Vl
a
n
-
in t10 1
Vlan-int103
Vlan-int103
Vlan-int104
Vlan-int104
Vlan-int105
Vlan-int105
To Next Page
Loading...
