EasyManua.ls Logo

3Com Switch 4800G 24-Port - Page 874

3Com Switch 4800G 24-Port
1246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
874 CHAPTER 67: QOS POLICY CONFIGURATION
# Create the traffic behavior (This operation leads you to traffic behavior view).
[Sysname] traffic behavior test
# Configure TP action for the traffic behavior.
[Sysname-behavior-test] car cir 640
Defining a Policy A policy associates a class with a traffic behavior. Each traffic behavior is comprised
of a group of QoS actions. A device executes these QoS actions in the order they
are defined.
Follow these steps to associate a traffic behavior with a class:
n
In a QoS policy with multiple class-to-traffic-behavior associations, if the action of
creating an outer VLAN tag, the action of setting customer network VLAN ID, or
the action of setting service provider network VLAN ID is configured in a traffic
behavior, we recommend you not to configure any other action in this traffic
behavior. Otherwise, the QoS policy may not function as expected after it is
applied.
Applying a Policy Configuration procedure
Follow these steps to apply a policy on a port:
Note that, when you apply a policy by using the qos apply policy command,
whether or not the inbound/outbound keyword can take effect depends on the
actions defined in the traffic behavior, as described in Table 70.
To do… Use the command… Remarks
Enter system view system-view -
Create a policy (This operation
leads you to policy view)
qos policy policy-name -
Specify the traffic behavior for a
class
classifier classifier-name behavior
behavior-name
Required
To do… Use the command… Remarks
Enter system view system-view -
Enter port
view or
port group
view
Enter
port view
interface interface-type
interface-number
Perform either of the two
operations.
The configuration performed in
Ethernet port view applies to the
current port only. The
configuration performed in port
group view applies to all the ports
in the port group.
Enter
port
group
view
port-group { manual
port-group-name | aggregation
agg-id }
Apply an associated
policy
qos apply policy policy-name
{ inbound | outbound }
Required
Table 70 The support for the inbound direction and the outbound direction
Action Inbound Outbound
Traffic accounting Supported Supported

Table of Contents

Related product manuals