Port-Based VLAN Configuration 89
Follow these steps to configure the Access-port-based VLAN in Ethernet port
view/port group view:
n
To add an Access port to a VLAN, make sure the VLAN already exists.
Configuring a
Trunk-Port-Based VLAN
A Trunk port may belong to multiple VLANs, and you can only perform this
configuration in Ethernet port view or port group view.
Follow these steps to configure the Trunk-port-based VLAN:
To do… Use the command… Remarks
Enter system view system-view -
Enter VLAN view vlan vlan-id Required
If the specified VLAN does not
exist, this command be
created first creates the VLAN
before entering its view.
Add an Access port to the
current VLAN
port interface-list Required
By default, system will add all
ports to VLAN 1.
To do… Use the command… Remarks
Enter system view system-view -
Enter
Ethernet
port view or
port group
view
Enter Ethernet
port view
interface interface-type
interface-number
Use either command
In Ethernet port view, the
subsequent configurations
only apply to the current port;
In port group view, the
subsequent configurations
apply to all ports in the port
group.
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }
Configure the port link type
as Access
port link-type access Optional
The link type of a port is
Access by default.
Add the current Access port
to a specified VLAN
port access vlan vlan-id Optional
By default, all Access ports
belong to VLAN 1.
To do… Use the command… Remarks
Enter system view system-view -
Enter
Ethernet port
view or port
group view
Enter
Ethernet port
view
interface interface-type
interface-number
Use either command
In Ethernet port view, the
subsequent configurations only
apply to the current port; in
port group view, the
subsequent configurations
apply to all ports in the port
group.
Enter port
group view
port-group { manual
port-group-name |
aggregation agg-id }
Configure the port link type
as Trunk
port link-type trunk Required
To Next Page
Loading...
