924 CHAPTER 73: CLUSTER MANAGEMENT CONFIGURATION
2 Configuring the management device
# Enable NDP globally and for the GigabitEthernet1/0/2,GigabitEthernet1/0/3
ports.
<Switch> system-view
[Switch] ndp enable
[Switch] interface GigabitEthernet1/0/2
[Switch- GigabitEthernet1/0/2] ndp enable
[Switch-GigabitEthernet1/0/2] quit
[Switch] interface GigabitEthernet1/0/3
[Switch-GigabitEthernet1/0/3] ndp enable
[Switch-GigabitEthernet1/0/3 quit
# Configure the period for the receiving device to keep NDP packets as 200
seconds.
[Switch] ndp timer aging 200
# Configure the interval to send NDP packets as 70 seconds.
[Switch] ndp timer hello 70
# Enable NTDP globally and for the GigabitEthernet1/0/2,GigabitEthernet1/0/3
ports.
[Switch] ntdp enable
[Switch] interface GigabitEthernet1/0/2
[Switch-GigabitEthernet1/0/2] ntdp enable
[Switch-GigabitEthernet1/0/2] quit
[Switch] interface GigabitEthernet1/0/3
[Switch-GigabitEthernet1/0/3] ntdp enable
[Switch-GigabitEthernet1/0/3] quit
# Configure the hop count to collect topology as 2.
[Switch] ntdp hop 2
# Configure the delay time for topology-collection request packets to be
forwarded on member devices as 150 ms.
[Switch] ntdp timer hop-delay 150
# Configure the delay time for topology-collection request packets to be
forwarded through the ports of member devices as 15 ms.
[Switch] ntdp timer port-delay 15
# Configure the interval to collect topology information as 3 minutes.
[Switch] ntdp timer 3
# Configure the management VLAN of the cluster as VLAN 10.
[Switch] vlan 10
[Switch-vlan10] quit
[Switch] management-vlan 10
# Configure the port connecting the management device to candidate devices as a
Trunk port and allow packets from the management VLAN to pass.
[Switch] interface GigabitEthernet 1/0/2
[Switch-GigabitEthernet 1/0/2] port link-type trunk
[Switch-GigabitEthernet 1/0/2] port trunk permit vlan 10
[Switch-GigabitEthernet 1/0/2] quit
[Switch] interface GigabitEthernet 1/0/3
[Switch-GigabitEthernet 1/0/3] port link-type trunk
To Next Page
Loading...
