3Com Switch 4800G 24-Port - Page 934

934 CHAPTER 75: SNMP CONFIGURATION
Follow these steps to configure SNMPv1 and SNMPv2c:
Add a new user to an SNMP
agent group
snmp-agent usm-user v3
user-name group-name
[[cipher ]
authentication-mode { md5
| sha } auth-password
[ privacy-mode { aes128 |
des56 } priv-password ]] [acl
acl-number ]
Required
If the cipher keyword is
specified, the arguments
auth-password and
priv-password are considered
as cipher text password.
Configure the maximum size
of an SNMP packet that can
be received or sent by an
SNMP agent
snmp-agent packet
max-size byte-count
Optional
1,500 bytes by default
Configure the switch fabric ID
for a local SNMP agent
snmp-agent local-switch
fabricid switch fabricid
Optional
Company ID and device ID by
default
Create or update the MIB
view content for an SNMP
agent
snmp-agent mib-view
{ excluded | included }
view-name oid-tree [ mask
mask-value ]
Optional
MIB view name is ViewDefault
and OID is 1 by default.
To do… Use the command… Remarks
Enter system view system-view -
Enable SNMP Agent snmp-agent Required
Disabled by default
You can enable SNMP Agent
through this command or any
commands that begin with
snmp-agent.
Configure SNMP Agent
system information
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version {{v1 | v2c | v3 }* |
all }}
Required
The defaults are as follows:
3Com Corporation for
contact,
Marlborough, MA for location
and SNMP v3 for the version.
Configur
e SNMP
NMS
access
right
Configur
e directly
Configur
e a
commun
ity name
snmp-agent community
{ read | write }
community-name [ acl
acl-number | mib-view
view-name ]*
Use either approach.
Both commands can be used
to configure SNMP NMS
access rights. The second
command was introduced to
be compatible with SNMPv3.
The community name
configured on NMS should be
consistent with the username
configured on the Agent.
Configur
e
indirectl
y
Configur
e an
SNMP
group
snmp-agent group { v1 |
v2c } group-name
[ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ]
[ acl acl-number ]
Add a
new
user to
an
SNMP
group
snmp-agent usm-user { v1 |
v2c } user-name group-name
[ acl acl-number ]
To do… Use the command… Remarks