940 CHAPTER 75: SNMP CONFIGURATION
■ The following log information is displayed on the terminal when NMS performs
the SET operation to Agent.
%Jan 1 02:59:42:576 2006 Sysname SNMP/6/SET:
seqNO = <11> srcIP = <1.1.1.2> op = <set> errorIndex = <0> errorStatus =<noError> node = <sysName(1.3.6.1.2.1.1.5.0)> value = <Sysnam
e>
n
The system information of the information center can be output to the terminal or
to the log buffer. In this example, SNMP log is output to the terminal. To set the
SNMP log to be output to other directions, refer to “Configuring Information
Center” on page 1009.
Table 74 Descriptions on the output field of SNMP log
Field Description
Jan 1 02:49:40:566 2006 The time when SNMP log is generated
seqNO Sequence number of the SNMP log ()
srcIP IP address of NMS
op SNMP operation type (GET or SET)
node Node name of the SNMP operations and OID of the instance
erroIndex Error index, with 0 meaning no error
errorstatus Error status, with noError meaning no error
value Value set when the SET operation is performed (This field is
initialized, meaning the value obtained with the GET
operation is not logged.)
When the value is a string of characters and the string
contains characters not in the range of ASCII 0 to 127 or
invisible characters, the string is displayed in hexadecimal.
For example, value = <81-43>[hex]
To Next Page
Loading...
