976 CHAPTER 78: DNS CONFIGURATION
Network diagram
Figure 292 Network diagram for dynamic domain name resolution
Configuration procedure
n
■ Before performing the following configuration, make sure that there is a route
between the device and the host, and configurations are done on both the
device and the host. For the IP addresses of the interfaces, see Figure 292.
■ This configuration may vary with different DNS servers. The following
configuration is performed on a Windows 2000 server.
■ Configure the DNS server
# Enter DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
In Figure 293, right click Forward Lookup Zones, select New zone, and then
follow the instructions to create a new zone.
Figure 293 Create a zone
# Create a mapping between the host name and IP address.
2.1.1.2/16
2.1.1.1/16
DNS server
Switch
DNS client
1.1.1.1/16
3.1.1.1/16
host.com
IP network
Host
To Next Page
Loading...
