AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 322 01/2011 Installation and activation
After the last line is validated, a summary of the network parameters is displayed for
confirmation.
If the summary is not correct:
•Press "
n" to restart network pre-configuration.
• If the summary is correct:
•Press "
y" and confirm by pressing "Return".
Nota :
By default, the EIP card(s) is/are automatically assigned an address and is/are
automatically activated. The values assigned are IPADR + 1 and IPADR + 2 (in case of
two EIP cards)
Attention :This feature may result in IP address clashes. It is advisable to check that the EIP card
IP address is correct for your address plan.
AASTRA 5000 CONFIGURATION / NETWORK
*-------------------------------------------------*
| ENTER IP ADDRESS: 100.100.40.150 |
| ENTER NETWORK MASK: 255.255.255.192 |
| ENTER GATEWAY: 100.100.40.129 |
*-------------------------------------------------*
AASTRA 5000 CONFIGURATION / NETWORK
*-------------------------------------------------*
| SUMMARY |
*-------------------------------------------------*
*-------------------------------------------------*
| IPADR = 100.100.40.150 |
| NETWORKMASK = 255.255.255.192 |
| GATEWAY = 100.100.40.129 |
| NETWORKADR = 100.100.40.128 |
| BROADCAST = 100.100.40.191 |
*-------------------------------------------------*
DO YOU CONFIRM (Y/N)? Y
To Next Page
Loading...
