Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Maintenance 01/2011 Page 433
• Activate the passive
RUCV-D card from the
AMP.
Refer to the document [1].
Nota : This new card is now the passive card (since it
is connected to the passive UCV-D card). It
must be activated in order to be taken into
account by the system.
• Perform a software check. • Check the software release of the card on the AMP (see
document [1]).
• Contact your distributor if the details do not coincide.
• Check the RUCV-D card
indicators.
For a card fitted with indicators, check that the yellow and/or green
indicators on the front panel are on, and that no red indicator is on
(refer to Section4.5 to check that the operating conditions indicated
by the LEDs are correct).
• Back up the customer
configuration.
Table 16:
OPERATION DETAILS OF THE OPERATION / COMMENTS
To Next Page
Loading...
Need help?
General
