Connecting a PC
WARNING!
Do not connect the PC directly to the control panel connector of the control
unit as this can cause damage.
A PC (with, for example, the Drive composer PC tool) can be connected as follows:
1. Connect a ACS-AP-… or ACH-AP-… control panel to the unit either
• by inserting the control panel into the panel holder or platform, or
• by using an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
5. See the documentation of the PC tool for setup instructions.
?
Start
Stop
Loc/Rem
?
Start
Stop
Loc/Rem
USB connected
3a
4
3b
2
2
Connecting a remote panel, or chaining one panel to
several drives
You can connect a drive control panel remotely to the drive, or chain the control panel
or a PC to several drives on a panel bus with a CDPI-01 communication adapter module.
See CDPI-01 communication adapter module user's manual (3AXD50000009929
[English]).
Installing option modules
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
1. Stop the drive and do the steps in section Electrical safety precautions (page 21)
before you start the work.
110 Electrical installation
To Next Page
Loading...
